AP-VTC1000 network Voice Transcoder device is a voice codec transcode device for network based digital voice recording and processing function along with AddPac VoIP gateway device. It is a network Voice Transcoder which is composed of two ports 10/100/1000Mbps Gigabit interface, DSP module slot for multi voice codec support.
IP based voice communication is growing fast as a substitution of existing PSTN phone network in accordance with fast network BcN (Broadband Convergence Network) such as ADSL, VDSL, and FTTH.
The demand for voice recording solution has been increasing in the structure of PSTN network and internet network. To meet the needs of customer satisfaction, next generation voice solution should be able to fulfill voice recording in PSTN network as well as in VoIP (Voice over IP) based internet network.
AddPac network based voice recording solution supports not only voice recording solution in one access point but it also supports total voice recording service architecture in BcN (Broadband convergence Network) along with various IP based VoIP devices such as analog/digital VoIP gateway, IP phones, and IP-PBX. IP based PSTN voice recording solution would satisfy the needs of demand.
Embedded Type Network Voice Codec Transcoder
AddPac AP-VTC1000 network voice codec transcoder device supports network based voice codec transcode service with high performance CPU module, real time OS (APOS), and embedded hardware
It has both a high performance RISC processor which support Gigabit Ethernet and stabilized embedded OS to optimize the performance and efficiency. This is a device for voice recording server (without voice codec transcode function) and convert G.723, G729, G726 into G.711. A voice recording server performs to save/manage the voice signal from various end-point based on G.711 and helps to transmit to media player.
Firmware Upgradeable Hardware Architecture
AddPac AP-VTC1000 IP Voice Transcoder¡¯s high performance RISC module is a programmable structure so that it is capable of improving functions, altering, and adding new features constantly. When additional features or changes are needed, simply download from the homepage or setting an auto upgrade option. You may use the latest features without much effort.
Support DSP Module for Multi Voice Codec
AddPac AP-VTC1000 IP Voice Transcoder supports a real time high quality voice codec transcode solution based on the state-of-the-art technology DSP. A captured voice data from end-point (VoIP gateway, IP Phone, etc) will be transmitted to commercial based recording server through IP network after voice transcoding. It not only provides voice codec such as G.711, G.726, but also low bit rate VoIP such as G.729, G.723.1. Transcoder module supports up to 64 channels with PCM (G.711).
A recorded voice data based on G.711 can be listened through speaker or headset.
Overall Features
High Performance RISC CPU and RTOS based
Embedded System
Support Two Gigabit Ethernet Interface
DSP Module for Multi Voice Codec (G.711,
G.726, G.729, G.723.1, etc)
LCD panel and On-Air Lamp for Device Status
Inspection
Microprocessor
High Performance RISC Integrated Host Processor
Memory
Flash Memory
16MB
SDRAM Memory
256MB
Boot Memory
512Kbyte Flash Memory
LAN Interface
LAN0 Port
One(1) 10/100/1000Mbps Gigabit Ethernet
LAN1 Port
One(1) 10/100/1000Mbps Gigabit Ethernet
Console Port
One(1) RS232C Interface
DSP Interface
DSP Module for Transcoding
Up to 64 voice channel
Power Requirement
Power VAC 110~220V, 50/60Hz, 12V 4A
Operating Temperature
0¡ÆC to + 45¡ÆC (32¡Æ to 112¡ÆF)
Storage Temperature
-40¡ÆC to + 85¡ÆC (-40¡Æ to 176¡ÆF)
Relative Humidity
5% to 95% (Non-condensing)
Dimensions
55 x 440 x 345(mm)
Basic Routing
Static Routing (IPv4)
Static / DHCP / PPPoE
VRRP(Virtual Redundancy Routing Protocol)
Network Management
SNMPv2/SNMPv3 Support
Standard & Enterprise SNMP MIB Support
Web Based Management using HTTP/HTTPS
Console / Telnet / Rlogin / SSH Interface
Security Function
Standard & Extended IP Access List
HTTPS / SSH Interface
Auto-disconnect Telnet/Console Session
Access Control for Local Service (FTP/Telnet/HTTP.)
Enable/Disable Network Services
Multi-Level User Account Management
Operation
&
Management
Configuration Backup & Restore for APOS Managements
Use Multiple APOS™ and Configuration
Auto Upgrade via HTTP/HTTPS
Debugging, System Auditing, and Diagnostics Support
Presentation
