Network interface: 10/100Mbps fast Ethernet
interface x 1
Support RS232/RS422/RS485 interface, alarm
input, relay output port
Support Power over Ethernet (PoE) : Option
Microprocessor
High Performance RISC H/W Architecture
Memory
Flash Memory
4Mbyte
SDRAM Memory
32Mbyte DDR
Network Interface
LAN Port
One(1) 10/100Mbps Fast Ethernet
Control & Display
LCD
Display Type : FSTN, Positive
Built-in Controller : ST7567
Blue LED Backlight
Active Area : 35.48(W) x 22.38(H)
Number of Dots : 128 x 64
RFID Card Sensor
Protocol Supported
ISO14443A/B all bit rates
> 106,212,424 and 848 kbps
Compatible to MiFare Classic
ISO15693 all modes
> 1.65/6.6 & 26.5 kbps
> Uplink 1 & 2 sub-carrier
Receiver
Rx Sensitivity down to 1mVrms
Rx Automatic Gain Control
Accept external baseband signal from
external circuitry for frame level processing
Integrated signal strength indicator (SSI)
On-Chip Framing handler for supported standard
Transmitter
Typical proximity operating distance up to
100mm.
Software configurable modulation index
Maximum driving current up to 200 mA/PIN @ 5V
Accept external baseband signal for RF modulation
Wide Transmitter driver supply range from 2.7~7.0V
Speaker
Internal Speaker
Impedance : 8 +-15%ohm at 1kHz, 1.0 Vrms
Sound Pressure : 90 +- 3dB at 0.1W/10 CM
at 800Hz, 1.0kHz, 1.2kHz, 1.5kHz
Resonance Level : 550Hz +- 20%Hz at Fo Hz, 1.0Vrms
Frequency Range : Fo Hz ~20kHz
Input Power : Normal : 1.0 W, Max : 2.0W
I/O Interface
I/O Port
RS232/RS485 Interface
Alarm Input : 2 Port
Relay Out : 2 Port
Power Requirement
External Power VAC 110~220 VAC, 50/60Hz, 12V 1A
PoE (Power over Ethernet)
IEEE802.3af compliant
Input voltage range 36V to 57V
Short-circuit Protection